P0287
Cylinder 9 Contribution/Balance
P0287 comes from the cylinder balance control of common-rail diesels: the engine module measures the crankshaft acceleration of each cylinder's power stroke, compares it with the average and gives a deviating cylinder more or less fuel. The code sets when the correction for cylinder 9 reaches its limit and the cylinder still does not keep up – GM at 95 % of a limit of about ±12–17 mm³ for 30 s, Ford above 90 % of the allowed 3.5–15 mg per stroke for 7.5 s; GM needs two trips. The code does not say whether there is too much or too little fuel – the correction value for cylinder 9 shows the direction: strongly negative means a leaking injector, strongly positive a weak injector or low compression. Cylinder 9 only exists on ten-cylinder diesels; GM and Ford documents stop at cylinder 8, so the description follows CARB and the siblings.
Possible causes
- Injector of cylinder 9 worn, coked or leaking high
- Engine software outdated or diagnosis too sensitive medium
- Injector correction codes not or wrongly programmed after replacement medium
- Low compression on cylinder 9 (valve, rings, injector seal) medium
- Crankshaft sensor or tone wheel learning faulty, dual-mass flywheel low
Symptoms
- Check engine light on
- Rough idle, shaking or knocking
- Loss of power or smoke
- Higher consumption, poor cold start
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0287
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.