OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P027A

Fuel Pump Module B Control Circuit/Open

On demand-controlled fuel systems the engine module does not drive the pump itself but sends a pump control module the desired pump output on a separate control line, usually as a duty cycle; the module reports back on a monitor line or via CAN. Module B is a second pump module, for example on dual-tank commercial vehicles. P027A is the counterpart of P025A: the control line from the engine module to pump module B is open or faulty. No manufacturer using P027A was found – Ford reports line faults of both modules together under P025A, GM only uses P025A; the description follows CARB's circuit monitoring requirement and Ford's module B check. If the second tank's pump gets no valid command, fuel may run short when running from that tank.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 7A

Possible causes

  • Control line to the pump module open or shorted, often along the frame high
  • Connector at the pump module corroded or wet (module often mounted on the frame) high
  • Pump control module faulty (input) medium
  • Module ground or supply poor medium

Symptoms

  • Check engine light (manufacturer-dependent)
  • Fuel shortage when running from the second tank
  • Starting problems, surging

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P027A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication