P0260
Injection Pump Fuel Metering Control B Intermittent (Cam/Rotor/Injector)
P0260 reports brief dropouts or jumps in the circuit of fuel metering actuator B on a diesel injection pump that do not last long enough for the low or high code (P0258/P0259) – typically a loose contact or a wire breaking under vibration. No manufacturer using P0260 was found; the description follows CARB's continuous circuit monitoring requirement and Saab's diagnosis of the same two-valve pump, which recommends a wiggle test with the valves activated.
Possible causes
- Loose contact or corrosion at the metering valve B connector high
- Broken or chafed wire in the harness to the pump (vibration, heat) medium
- Metering valve B with internal dropouts medium
- Unstable supply or ground low
Symptoms
- Check engine light on
- Occasional jerking or brief loss of power
- Limp mode possible
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0260
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.