P025E
Turbocharger/Supercharger Boost Sensor A Intermittent/Erratic
Boost sensor A measures the pressure between charge air cooler and throttle (Ford TIP, GM TIAP). P025E counts brief excursions outside its valid voltage range that are each too short for the low or high code P0237/P0238 – Ford's limits are below 0.19 V and above 4.88 V. Ford counts these events continuously and sets P025E after 10 in one drive cycle. Boost control then runs on a substitute value or is switched off, leaving only base boost. Typical causes are a loose or corroded connector or a wire breaking under vibration and heat.
Possible causes
- Loose contact or corrosion at the sensor connector high
- Wire or 5 V reference breaking from vibration or heat medium
- Sensor faulty internally (erratic signal) medium
- Shared 5 V reference disturbed by another sensor low
Symptoms
- Check engine light on
- Occasional loss of power, boost limited
- Jerking on acceleration
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P025E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.