P025D
Fuel Pump Module A Control Circuit High
On demand-controlled fuel systems the engine module does not drive the pump itself but sends a pump control module the desired pump output on a separate control line, usually as a duty cycle; the module reports back on a monitor line or via CAN. P025D means the control circuit to pump module A reads high, typically a short to voltage. On Ford's 3.0 diesel the pump module detects it; on the 6.7 it means a short to voltage on the low side of the pump relay – both continuously monitored and set within 0.5 s. Depending on the design the pump then runs all the time or not at all.
Possible causes
- Control line shorted to battery voltage or another wire high
- Moisture in the connector (leakage to voltage) medium
- Pump control module faulty medium
- Relay stuck or faulty (Ford 6.7) low
Symptoms
- Check engine light on
- Pump runs all the time or not at all
- Starting problems
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P025D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.