OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P025C

Fuel Pump Module A Control Circuit Low

On demand-controlled fuel systems the engine module does not drive the pump itself but sends a pump control module the desired pump output on a separate control line, usually as a duty cycle; the module reports back on a monitor line or via CAN. P025C means the control circuit to pump module A reads low, typically a short to ground. On Ford's 3.0 diesel the pump module detects it; on the 6.7 it means a short on the low side of the pump relay – both within 0.5 s. FCA documents it with the warning light on and sometimes a start followed by stalling, often together with P01C6 and P016F; the checks cover the pump module connector, the low-pressure sensor and a ground point for water, corrosion and pushed-back pins.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 5C

Possible causes

  • Control line chafed to ground at the frame high
  • Water or corrosion at the pump module connector high
  • Ground point loose or corroded medium
  • Pump control module faulty internally medium
  • Pump relay faulty (Ford 6.7) low

Symptoms

  • Check engine light on
  • Engine starts and dies again
  • Starting problems
  • Loss of power from low supply pressure

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P025C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication