OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P025B

Fuel Pump Module A Control Circuit Range/Performance

On demand-controlled fuel systems the engine module does not drive the pump itself but sends a pump control module the desired pump output on a separate control line, usually as a duty cycle; the module reports back on a monitor line or via CAN. P025B means pump module A receives a signal, but an invalid command – the duty cycle is outside the valid window or implausible. Ford's module signals this with a 20 % (±4 %) duty cycle on its monitor line; the check runs continuously at 11–16 V over 2–5 s. Whether the warning light comes on depends on the vehicle. Typical causes are contact resistance in the control line or connector that distorts the duty cycle, a poor ground or a faulty module.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 5B

Possible causes

  • Contact resistance or corrosion in the control line or connector distorting the duty cycle high
  • Pump control module faulty medium
  • Interference or poor ground between engine module and pump module medium
  • Engine module software or output low

Symptoms

  • Check engine light (manufacturer-dependent)
  • Hard or no start
  • Rough idle, surging
  • Lack of power from wrong fuel pressure

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P025B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication