P0259
Injection Pump Fuel Metering Control B High (Cam/Rotor/Injector)
Fuel metering actuator B is a second electrically controlled metering valve on a diesel injection pump; A has the codes P0251–P0255. P0259 means its circuit reads high or draws too much current – a short to voltage or a shorted turn. Saab's 3.0 V6 diesel, whose pump has two metering valves, uses it for an internal short in one of the valves lasting over 2.1 s: limp mode with limited pedal response, injection quantity and rail pressure (60 MPa), and the warning light if it recurs on the next trip. GM and Ford use other codes for this part (P0090–P0092, P0001–P0004).
Possible causes
- Metering valve B shorted internally high
- Control wire to the valve shorted to voltage, chafing medium
- Connector at the valve corroded or wet medium
- Driver stage in the engine module faulty low
Symptoms
- Check engine light on
- Limp mode with limited power and speed
- Hard starting, engine may stall
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0259
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9600/2002/2-engine/engine-management-system-v6-diesel/fault-diagnosis-diagnostic-trouble-codes/p0259
- saabwisonline.com/9-5-9600/2002/2-engine/engine-management-system-v6-diesel/technical-description/fuel-pressure-valve-fuel-rail