P0258
Injection Pump Fuel Metering Control B Low (Cam/Rotor/Injector)
These codes cover the electrically controlled fuel metering actuator on a diesel injection pump – on common rail usually an inlet metering valve on the high-pressure pump that sets how much fuel is compressed. P0258 means the actuator B circuit reads low. The only manufacturer found, Saab with its 3.0 V6 diesel of the early 2000s, uses it not for a second valve but for the shared supply of both metering valves: a short to ground or open for more than about 1 s triggers limp mode with limited pedal response and injection quantity, rail pressure capped at 60 MPa and idle raised to 1,000 rpm; the warning light comes on if it recurs on the next trip.
Possible causes
- Supply wire, fuse or relay of the metering valves open or shorted to ground high
- Connector at the pump corroded or loose medium
- Metering valve shorted to ground internally medium
- Engine module low
Symptoms
- Check engine light on (after the second trip)
- Loss of power, limp mode
- Raised idle speed in limp mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0258
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9600/2002/2-engine/engine-management-system-v6-diesel/fault-diagnosis-diagnostic-trouble-codes/p0258
- saabwisonline.com/9-5-9600/2002/2-engine/engine-management-system-v6-diesel/technical-description/fuel-pressure-valve-fuel-rail