P0255
Injection Pump Fuel Metering Control A Intermittent (Cam/Rotor/Injector)
These codes cover the electrically controlled fuel metering actuator on a diesel injection pump – on common rail usually an inlet metering valve on the high-pressure pump that sets how much fuel is compressed. P0255 reports brief open or short circuits in the actuator A circuit that come and go – typically a loose contact or a wire breaking under vibration. No manufacturer using it with exactly this meaning was found; a Ram 6.7 Cummins code list names it as a circuit performance fault instead. The description follows CARB's continuous circuit monitoring requirement and the documented A siblings.
Possible causes
- Loose contact or corrosion at the metering actuator connector high
- Harness chafing intermittently (vibration) medium
- Actuator coil with a temperature-dependent fault low
- Engine module low
Symptoms
- Check engine light (often goes out again)
- Brief jerking or power dips
- Occasional limp mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0255
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.