P0254
Injection Pump Fuel Metering Control A High (Cam/Rotor/Injector)
These codes cover the electrically controlled fuel metering actuator on a diesel injection pump – on common rail usually an inlet metering valve on the high-pressure pump that sets how much fuel is compressed. P0254 means the actuator A circuit reads high or draws too much current – typically the control wire shorted to voltage. Saab's 2011 9-5 diesel sets it after 1 s with the warning light at once. On Saab's 3.0 V6 diesel a short to voltage of more than 0.31 s stops the engine, because a permanently energised valve can no longer control quantity and pressure. Ford's equivalent P0004 sets above 3.7 A; GM uses P0092.
Possible causes
- Control wire shorted to voltage high
- Metering valve with shorted turns (overcurrent) medium
- Connector corrosion with leakage current low
- Driver stage in the engine module faulty low
Symptoms
- Check engine light on
- Engine stalls or will not start (Saab 3.0 diesel)
- Limp mode, loss of power
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0254
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9650/2011/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p0251-p0254
- saabwisonline.com/9-5-9600/2002/2-engine/engine-management-system-v6-diesel/fault-diagnosis-diagnostic-trouble-codes/p0254
- fordservicecontent.com/Ford_Content/catalog/motorcraft/obd-summary-diesel-2023.pdf