P0253
Injection Pump Fuel Metering Control A Low (Cam/Rotor/Injector)
These codes cover the electrically controlled fuel metering actuator on a diesel injection pump – on common rail usually an inlet metering valve on the high-pressure pump that sets how much fuel is compressed. P0253 means the actuator A circuit reads low. Saab's 2011 9-5 diesel uses it for a control wire shorted to ground for more than 1 s, with the warning light at once. Saab's 3.0 V6 diesel, whose pump has two metering valves, also includes an open circuit (over 2.1 s) and goes into limp mode: limited pedal response and injection quantity, rail pressure capped at 60 MPa, warning light if the fault recurs on the next trip. Ford's equivalent is P0003, GM's P0091.
Possible causes
- Control wire to the metering actuator chafed to ground high
- Connector or wire open (where makers include it under low) medium
- Metering actuator faulty internally medium
- Engine module faulty low
Symptoms
- Check engine light on
- Limp mode with limited power and speed
- Hard starting possible
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0253
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9650/2011/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p0251-p0254
- saabwisonline.com/9-5-9600/2002/2-engine/engine-management-system-v6-diesel/fault-diagnosis-diagnostic-trouble-codes/p0253
- saabwisonline.com/9-5-9600/2002/2-engine/engine-management-system-v6-diesel/technical-description/fuel-pressure-valve-fuel-rail