OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0251

Injection Pump Fuel Metering Control A (Cam/Rotor/Injector)

These codes cover the electrically controlled fuel metering actuator on a diesel injection pump. On older distributor pumps it was a solenoid that set the injected quantity; on common rail it is usually an inlet metering valve on the high-pressure pump that lets only as much fuel into the pumping elements as the rail needs, instead of spilling the excess through a pressure valve. Manufacturers use different codes for this part: Ford P0001–P0004, GM Duramax P0090–P0092. P0251 is the general circuit fault of actuator A. Saab's 2011 9-5 diesel uses it for an open circuit of the pressure regulator on the high-pressure pump: if the control wire does not show the expected voltage with the driver off for more than 1 s, the code sets with the warning light at once. Depending on the system, rail pressure and power are then limited.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 51

Possible causes

  • Metering actuator coil open high
  • Connector at the actuator corroded or loose, broken wire high
  • Supply voltage to the actuator missing medium
  • Distributor pump: internal electronics or quantity valve faulty medium
  • Driver stage in the engine module faulty low

Symptoms

  • Check engine light on
  • Loss of power, limp mode
  • Rough idle or hunting
  • Hard starting or stalling

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0251

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication