OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P024F

Charge Air Cooler Bypass Position Sensor A Circuit High

The charge air cooler bypass is a flap or valve that routes compressed air around the charge air cooler, so the engine and exhaust warm up faster after a cold start; when warm it closes or opens partly to control intake air temperature. It is driven by an electric motor with a built-in position sensor or by a solenoid and vacuum can. Its position sensor is usually built into the actuator, with a 5 V reference and a ratiometric signal. P024F means the signal is above its upper limit – typically an open sensor ground or a signal shorted to voltage. Bypass control is then switched off and the flap stays in its rest position. No manufacturer document using this code was found – GM and Ford do not use the bypass codes; the description rests on CARB's component monitoring requirement and a Bosch patent on the bypass valve.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 4F

Possible causes

  • Sensor ground open high
  • Signal shorted to 5 V or system voltage medium
  • Sensor faulty medium
  • Connector corroded medium

Symptoms

  • Check engine light on
  • Depending on the rest position: longer warm-up or higher charge air temperature with slight loss of power
  • Often nothing noticeable while driving

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P024F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication