OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P023F

Fuel Pump Secondary Circuit/Open

The fuel pump circuit has two sides: the primary circuit is the engine module's output to the fuel pump relay coil (or to a pump control module), the secondary circuit is the power circuit from relay contact or module to the pump itself. P023F means the power circuit to the pump is open. GM pumps with their own power module, whose speed is controlled by rail pressure, measure the pump current: if it stays below 1 A (older modules 0.5 A) although the pump is commanded, the code sets with the warning light in the first trip, and fuel pressure diagnostics are suspended. The cause lies in the wire from module to pump or its return, the pump connector or the pump motor itself. The pump stops, so the engine will not start or dies – there is no limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 3F

Possible causes

  • Pump connector at tank flange or pump module open or corroded high
  • Fuel pump open internally (brushes, winding) high
  • Wire from module to pump or return wire open medium
  • Pump control module faulty low

Symptoms

  • Engine does not start, no pump noise
  • Engine stalls while driving
  • Check engine light on

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P023F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication