P023D
Manifold Absolute Pressure - Turbocharger/Supercharger Boost Sensor A Correlation
P023D compares the manifold pressure sensor (after the throttle) with boost sensor A (before the throttle): with the engine stopped both must read the same ambient pressure. Saab's 2.8 V6 checks this once per trip with the ignition on before starting and sets the code at a difference of more than 12 kPa, with the warning light and limp mode limited to 170 Nm. The code does not say which sensor is wrong – barometric pressure as a third value decides. Electrical faults of either sensor (P0107/P0108, P0237/P0238) block the test and must be fixed first. GM and Ford run the same comparison but report it as P0236, P0106 or P2227.
Possible causes
- Manifold or boost sensor drifting or dirty high
- Contact resistance at connector or ground of one sensor medium
- Pressure port or hose of one sensor blocked (oil sludge, ice) medium
- Engine module or reference voltage low
Symptoms
- Check engine light on
- Limp mode, limited power
- Otherwise often unremarkable
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P023D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.