OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P022A

Charge Air Cooler Bypass Control A Circuit/Open

The charge air cooler bypass is a flap or valve that routes compressed air around the charge air cooler, so the engine and exhaust warm up faster after a cold start; when warm it closes or opens partly to control intake air temperature. It is driven by an electric motor with a built-in position sensor or by a solenoid and vacuum can. P022A is the general circuit fault of the actuator drive, mainly an open circuit: the driver sees no current or an output voltage outside its window. The module then switches bypass control off and the flap stays in its rest position. No manufacturer document using this code was found – GM and Ford do not use the bypass codes; the description rests on CARB's component monitoring requirement and a Bosch patent on the bypass valve.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 2A

Possible causes

  • Wire or connector at the bypass actuator open high
  • Actuator or solenoid of the bypass flap faulty (coil, motor) medium
  • Fuse or relay of the actuator supply low
  • Driver stage in the engine module faulty low

Symptoms

  • Check engine light on
  • Depending on the rest position: longer warm-up or higher charge air temperature with slight loss of power
  • Often nothing noticeable while driving

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P022A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication