OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0228

Throttle/Pedal Position Sensor/Switch C Circuit High

Sensor C is a third throttle or pedal position signal; its role depends on the manufacturer. Ford uses it for the sensor of the second throttle body on engines with two throttles and digital (SENT) sensors, GM does not use it. P0228 means the signal of sensor C is above its upper limit – typically an open sensor ground, which pulls the signal up to the reference, or a signal wire shorted to voltage. The module discards sensor C and runs in limp mode with limited power. Ford reports low and high faults of its digital sensor C as U2111/U2112 instead, so no manufacturer using exactly this code was found; the description follows CARB's input monitoring requirement and the sensor A/B siblings.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 28

Possible causes

  • Sensor ground (low reference) open high
  • Signal wire shorted to 5 V or system voltage medium
  • Sensor C or throttle body faulty medium
  • Connector corroded or water ingress medium
  • Engine module faulty low

Symptoms

  • Check engine light (Ford also the wrench light)
  • Limp mode with limited power
  • Delayed or missing throttle response
  • Rough or raised idle

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0228

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication