OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0227

Throttle/Pedal Position Sensor/Switch C Circuit Low

Sensor C is a third throttle or pedal position signal; its role depends on the manufacturer. Ford uses it for the sensor of the second throttle body on engines with two throttles and digital (SENT) sensors, GM does not use it. P0227 means the signal of sensor C is below its lower limit – on an analogue sensor a signal wire shorted to ground or an open signal or 5 V reference wire. The module discards sensor C and runs in limp mode with limited power. Ford reports low and high faults of its digital sensor C as U2111/U2112 instead, so no manufacturer using exactly this code was found; the description follows CARB's input monitoring requirement and the sensor A/B siblings.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 27

Possible causes

  • Signal wire of sensor C shorted to ground or open (chafing, connector) high
  • 5 V reference to the sensor open or loaded medium
  • Sensor C or second throttle body faulty medium
  • Corrosion or water in the throttle body connector medium
  • Engine module input faulty low

Symptoms

  • Check engine light (Ford also the wrench light)
  • Limp mode with limited power
  • Delayed or missing throttle response
  • Rough or raised idle

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0227

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication