OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0226

Throttle/Pedal Position Sensor/Switch C Circuit Range/Performance

Sensor C is a third throttle or pedal position sensor whose role depends on the manufacturer. Ford uses it for the sensor of the second throttle body on engines with two throttles and digital (SENT) sensors; with other makes it can be a further pedal or throttle channel. P0226 is the plausibility fault: the signal of sensor C is electrically valid but does not match its partner sensor or the airflow model. No manufacturer using exactly this code was found – Ford does not report sensor C plausibility separately. The logic follows the sibling checks on sensors A and B (Bosch: more than 9 % deviation, Ford: more than 7 degrees). The result is limp mode with reduced power.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 26

Possible causes

  • Wear or dirt on sensor C or the second throttle body high
  • Contact resistance at connector or wiring medium
  • Throttle dirty or sticking medium
  • Engine module or software low

Symptoms

  • Check engine light on
  • Limp mode, reduced power
  • Jerking, poor throttle response

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0226

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication