P0224
Throttle/Pedal Position Sensor/Switch B Circuit Intermittent
With electronic throttle control the throttle body carries two position sensors, A and B, usually with opposite or offset signals, and the engine module compares them (correlation code P2135). GM and Ford give the pedal sensors their own codes (P2120 ff), so B is in practice the second throttle sensor. P0224 reports brief dropouts or jumps of sensor B that do not last long enough for the steady fault codes. No manufacturer using exactly this code was found: GM counts intermittent faults within P0222/P0223, and Ford's digital sensors report intermittent faults as P0124 for sensor A and P0229 for sensor C – after more than 0.4 s, while a steady fault needs over 4 s. Depending on frequency the result is jerking or brief limp mode.
Possible causes
- Loose contact or corroded connector at the throttle body high
- Worn spot on the sensor track high
- Wire breaking from engine movement or vibration medium
- Engine module or ground connection low
Symptoms
- Occasional jerking or power dips
- Brief limp mode
- Check engine light (sometimes only intermittently)
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0224
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.