P0221
Throttle/Pedal Position Sensor/Switch B Circuit Range/Performance
With electronic throttle control the throttle body carries two position sensors, A and B, usually with opposite or offset signals, and the engine module compares them (correlation code P2135). GM and Ford give the pedal sensors their own codes (P2120 ff), so B is in practice the second throttle sensor. P0221 is the plausibility fault: the signal of sensor B is electrically valid but does not match sensor A or the throttle position expected from airflow. Bosch ME9 engines (Saab) set it at a deviation of more than 9 %, older Ford systems at more than 7 degrees between the sensors without the warning light; many newer engines report this only as P2135. The module carries on with sensor A, limits throttle opening and power and switches off cruise control.
Possible causes
- Worn track of sensor B (signal jumps) high
- Contact resistance at connector or wiring medium
- Throttle dirty or sticking medium
- Mass airflow sensor fault or false air low
Symptoms
- Check engine light on
- Limp mode, reduced power
- Rough idle, jerking
- Cruise control disabled
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0221
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.