OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P021E

Cylinder 11 Injection Timing

P021E reports a fault in the injection timing of cylinder 11 on a diesel engine. Unlike P01DF/P01E0 ('over retarded/advanced', the result of the injector learning routine in overrun), this code has no direction, and what it checks is up to the manufacturer. A cylinder 11 code only applies to engines with 11 or more cylinders. No manufacturer or vehicle using it was found – GM's documents stop at cylinder 8 (P021B), FCA's at cylinder 6, and Ford uses other codes. The description therefore follows the documented siblings: GM checks the injector's current rise electrically, FCA ties the code to injector learning. CARB requires diesel engines to detect injection that is too early or too late.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 1E

Possible causes

  • Injector of cylinder 11 faulty (coil, armature, wear, deposits) high
  • Injector wiring or connector: contact resistance, corrosion, chafing medium
  • Engine software sets the code falsely (update available for some models) low
  • Injector driver stage or boost voltage in the engine module low
  • Wrong injector code, contaminated fuel or loose injector clamp low

Symptoms

  • Check engine light on
  • Rough running or misfire, rough idle
  • Loss of power, smoke or knocking possible

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P021E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication