P021D
Cylinder 10 Injection Timing
P021D reports a fault in the injection timing of cylinder 10 on a diesel engine. Unlike P01DD/P01DE ('over retarded/advanced', the result of the injector learning routine in overrun), this code has no direction, and what it checks is up to the manufacturer. A cylinder 10 code only applies to engines with 10 or more cylinders. No manufacturer or vehicle using it was found – GM's documents stop at cylinder 8 (P021B), FCA's at cylinder 6, and Ford uses other codes. The description therefore follows the documented siblings: GM checks the injector's current rise electrically, FCA ties the code to injector learning. CARB requires diesel engines to detect injection that is too early or too late.
Possible causes
- Injector of cylinder 10 faulty (coil, armature, wear, deposits) high
- Injector wiring or connector: contact resistance, corrosion, chafing medium
- Engine software sets the code falsely (update available for some models) low
- Injector driver stage or boost voltage in the engine module low
- Wrong injector code, contaminated fuel or loose injector clamp low
Symptoms
- Check engine light on
- Rough running or misfire, rough idle
- Loss of power, smoke or knocking possible
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P021D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.