P021A
Cylinder 7 Injection Timing
P021A reports a fault in the injection timing of cylinder 7 on a diesel engine. Unlike P01D7/P01D8 ('over retarded/advanced', the result of the injector learning routine in overrun), this code has no direction, and what it checks is up to the manufacturer. GM uses it as an electrical check on the 6.6 litre L5P Duramax V8: at every injection the engine module measures how long the injector current takes to reach its pull-in level of 13 A. If on the V8 that time is outside 60–150 µs in 10 of 20 samples, the code sets and the warning light comes on in the first trip. For 2020–2021 Silverado/Sierra HD, GM issued a software update against false setting. FCA's V6 and Ford do not use it.
Possible causes
- Injector of cylinder 7 faulty (coil, armature, wear, deposits) high
- Injector wiring or connector: contact resistance, corrosion, chafing medium
- Engine software sets the code falsely (update available for some models) medium
- Injector driver stage or boost voltage in the engine module low
- Wrong injector code, contaminated fuel or loose injector clamp low
Symptoms
- Check engine light on
- Rough running or misfire, rough idle
- Loss of power, smoke or knocking possible
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P021A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.