OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0215

Engine Shutoff Solenoid

The engine shutoff solenoid is the electric stop valve on older diesel injection pumps, mainly distributor pumps. It is energised with the ignition on and lets fuel into the pump; with no current a spring closes it, the pump runs dry and the engine stops – also as a safety backup if the governor fails. P0215 reports a fault in this solenoid or its supply, typically a broken coil, a sticking plunger, a blown fuse or relay, or a wiring fault. The result is either an engine that will not start or dies, or one that keeps running after switch-off. Newer diesels stop through the injectors or a fuel shutoff valve with its own codes P0005–P0007. No manufacturer document describing P0215 was found; the description rests on CARB's requirements for output components and a Bosch patent on the valve.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 15

Possible causes

  • Shutoff solenoid faulty (open coil, sticking plunger) high
  • Relay or fuse in the supply circuit faulty high
  • Broken wire, corrosion or ground fault at the pump connector medium
  • Pump control module faulty low
  • Engine module driver faulty low

Symptoms

  • Engine does not start or stalls while driving
  • Engine keeps running after ignition off (solenoid stuck open)
  • Check engine light on
  • Stumbling with a loose contact

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0215

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication