OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0214

Cold Start Injector 2

A cold start injector is an additional injector in the intake manifold that sprays extra fuel for a few seconds while a cold engine is cranked. In classic Bosch systems a thermo-time switch on the block powers it directly, without the engine module – such systems cannot set a code at all. A code is only possible where the engine module drives the valve and monitors its circuit, as CARB requires for output components. From the 1990s the main injectors took over cold-start enrichment, so the code only fits early OBD II engines. P0214 concerns cold start injector 2, for example on a second intake bank. No manufacturer using it was found in GM, Ford or Saab documents.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 14

Possible causes

  • Connector or wire corroded or open high
  • Valve coil open or valve stuck medium
  • Thermo-time switch or control relay faulty medium
  • Driver stage in the engine module faulty low

Symptoms

  • Check engine light on
  • Poor cold start, long cranking in cold weather
  • Leaking valve: hot-start problems, flooding, black smoke

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0214

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication