OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0213

Cold Start Injector 1

A cold start injector is an additional injector in the intake manifold that sprays extra fuel for a few seconds while a cold engine is cranked. In classic Bosch systems a thermo-time switch on the block powers it directly, without the engine module – such systems cannot set a code at all. A code is only possible where the engine module drives the valve and monitors its circuit, as CARB requires for output components. From the 1990s the main injectors took over cold-start enrichment, so the code only fits early OBD II engines. P0213 concerns cold start injector 1. No manufacturer using it was found in GM, Ford or Saab documents.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 13

Possible causes

  • Connector or wire corroded or open high
  • Valve coil open or valve stuck medium
  • Thermo-time switch or control relay faulty medium
  • Driver stage in the engine module faulty low

Symptoms

  • Check engine light on
  • Poor cold start, long cranking in cold weather
  • Leaking valve: hot-start problems, flooding, black smoke

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0213

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication