OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0208

Cylinder 8 Injector A Circuit/Open

P0208 reports an electrical fault, mainly an open circuit, in the injector circuit of cylinder 8. The engine module watches each injector output: GM flags an open circuit at an impedance of 200 kΩ or more – on direct injection and diesel engines in 10 of 20 or 5 of 10 samples and with the warning light in the first trip, on some port-injected engines only after two trips. Ford's port injection reads a fault bit from the driver chip that covers open, short to ground and short to voltage alike; Ford diesels report only the open circuit here and shorts as P0282/P0283. On direct injection the affected injector is switched off; the cylinder misfires.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 08

Possible causes

  • Connector at the cylinder 8 injector loose, corroded or with a broken or pushed-back pin high
  • Injector coil open medium
  • Wire between module and injector open or chafed (heat, rodents) medium
  • Injector supply missing (fuse, relay) – then usually several cylinders at once low
  • Driver stage in the engine module faulty low

Symptoms

  • Check engine light on
  • Misfire and rough running, misfire code P0308
  • Loss of power, rough idle
  • Limp mode possible on diesel and direct injection

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0208

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication