P01F8
Engine Coolant Heater A Control Circuit Driver Current/Temperature Too High
The engine module switches an electric coolant heater A through a power stage (driver). This code means the driver itself has reported excessive current or overheating and has shut down to protect itself – it concerns the control circuit, not the coolant temperature. Such heaters warm the coolant around a cold start, shortening warm-up and providing cabin heat sooner; a GM patent describes how the module recognises a pre-heated engine so other temperature diagnostics do not misfire. No manufacturer using this code family was found in GM, Ford or FCA documents; the description rests on CARB's requirements for output components. Siblings for heater A are P01E8–P01EB.
Possible causes
- Short or partial short in heater element A high
- Wiring or connector chafed to ground, moisture in connector medium
- Driver stage in the module or relay faulty or overheated low
- Heater running without coolant (low level, air pocket) low
Symptoms
- Check engine light or warning message (manufacturer-dependent)
- Slow warm-up, little heat in cold weather
- Further heater codes possible (P01E9)
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P01F8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.