P01F7
O2 Sensor Signal Biased/Stuck Rich Bank 1 Sensor 4
Sensor 4 on bank 1 is a fourth oxygen sensor, downstream of a further converter. No manufacturer or vehicle using sensor 4 codes could be identified (GM and Ford documents stop at sensor 3); the description follows CARB's requirements for downstream sensors and GM's checks on sensor 2. P01F7 means the sensor stays rich: when the module leans the mixture or cuts fuel on overrun, the signal does not drop into the lean range. CARB names exactly this rich-to-lean transition during fuel cut-off as the minimum check for downstream sensors; GM tests sensor 2 this way as a two-trip fault. Usual causes are a sooted or oil-fouled sensor or a signal wire shorted to the heater supply.
Possible causes
- Sensor sooted, oil-fouled or aged high
- Signal wire shorted to voltage (e.g. heater supply) medium
- Mixture genuinely rich (leaking injector, coolant or oil burning) low
Symptoms
- Check engine light on (usually after two drive cycles)
- Catalyst monitor readiness possibly not set
- Usually no change in driving
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P01F7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.