OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P01F5

O2 Sensor Circuit No Activity Detected Bank 1 Sensor 4

Sensor 4 on bank 1 is a fourth oxygen sensor, downstream of a further converter. No manufacturer or vehicle using sensor 4 codes could be identified (GM and Ford documents stop at sensor 3); the description follows CARB's requirements for downstream sensors and GM's checks on sensor 2. P01F5 means that with a warm engine and heated sensor the signal does not switch between rich and lean but stays in the middle or at the bias voltage the module applies. For sensor 2, GM detects this when the signal stays above 1.7 V of a 1.9 V bias, a two-trip fault. Usual causes are an open signal or ground wire or a dead sensor.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / F5

Possible causes

  • Signal or ground wire open, connector corroded high
  • Sensor aged or poisoned, produces no voltage medium
  • Sensor heater faulty, sensor does not reach operating temperature medium
  • Exhaust leak upstream of the sensor low

Symptoms

  • Check engine light on (usually after two drive cycles)
  • Catalyst monitor readiness possibly not set
  • Usually no change in driving

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P01F5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication