P01F2
O2 Sensor Circuit Low Voltage Bank 1 Sensor 4
Sensor 4 on bank 1 is a fourth oxygen sensor, behind a third converter or converter brick. The OBD standard provides for up to four sensors per bank, and the code standard defines sensor 4 for bank 1 only. No manufacturer or vehicle using these codes could be identified; the description rests on CARB's requirements for downstream oxygen sensors and the logic of sensors 2 and 3. A switching sensor delivers about 0.1–0.9 V. P01F2 means the signal stays near 0 V – typically a signal wire shorted to ground, a faulty sensor or an exhaust leak ahead of it; GM checks its other downstream sensors for a signal below about 40–60 mV.
Possible causes
- Signal wire shorted to ground high
- Sensor faulty medium
- Exhaust leak ahead of the sensor medium
Symptoms
- Check engine light on (usually after two drive cycles)
- Catalyst monitor readiness possibly not set
- Usually no change in driving
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P01F2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.