OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P01EB

Engine Coolant Heater A Control Circuit Performance

Engine coolant heater A is an electric coolant heater switched by the engine module, directly or via a relay or power stage, to shorten warm-up – less cold-start emissions and faster cabin heat; A and B denote two separately switched heaters or stages. It is not the same as a mains-powered block heater (which the vehicle does not control) or the electrically heated thermostat (P0597–P0599). CARB requires output components to be checked for correct response or at least for circuit faults. This code reports that the heater circuit is electrically intact but the heater does not work as commanded – for example a sticking relay or a weak element. No manufacturer using these codes was found in the GM, Ford or NHTSA documents checked; the typical driver diagnosis (open circuit detected with the driver switched off, as GM does for other outputs) is an analogy, and thresholds are unknown.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / EB

Possible causes

  • Relay sticking or not switching (burnt contacts) high
  • Heater element aged or scaled, output too low medium
  • Voltage drop in the load circuit or switched off by power management medium
  • Low coolant or air at the heater low

Symptoms

  • Check engine light on
  • Longer warm-up, cabin heat slower in winter
  • Usually no change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P01EB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication