P01E8
Engine Coolant Heater A Control Circuit/Open
Engine coolant heater A is an electric coolant heater switched by the engine module, directly or via a relay or power stage, to shorten warm-up – less cold-start emissions and faster cabin heat; A and B denote two separately switched heaters or stages. It is not the same as a mains-powered block heater (which the vehicle does not control) or the electrically heated thermostat (P0597–P0599). CARB requires output components to be checked for correct response or at least for circuit faults. This code reports an open control circuit – the module detects missing continuity, typically with the driver switched off. No manufacturer using these codes was found in the GM, Ford or NHTSA documents checked; the typical driver diagnosis (open circuit detected with the driver switched off, as GM does for other outputs) is an analogy, and thresholds are unknown.
Possible causes
- Control wire or connector to the heater or relay open high
- Heater element burnt out or relay coil open high
- Fuse in the load circuit blown medium
- Control module output stage faulty low
Symptoms
- Check engine light on
- Longer warm-up, cabin heat slower in winter
- Usually no change in driving
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P01E8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.