P01E7
Engine Coolant Temperature Sensor 3 Circuit Intermittent/Erratic
Coolant temperature sensor 3 is a third NTC coolant sensor on engines with thermal management or split cooling circuits; its position is defined by the manufacturer – on Jaguar Land Rover's 2018–2019 Ingenium petrol engines it sits in the engine block water jacket, on Audi's 3.0 TFSI V6 it is part of the thermal management. As with every NTC sensor, a low signal voltage means hot and a high one cold. CARB requires such additional sensors to be monitored from model year 2019 onwards. P01E7 covers jumps or brief dropouts in the signal – coolant temperature cannot change that fast, so loose contacts, wires broken by vibration or a sensor that opens internally when the temperature changes are the usual causes. No manufacturer document using exactly this code was found; it is described by analogy with its documented sibling codes and the NTC principle.
Possible causes
- Loose contact at connector or pins high
- Wire break in the harness (movement, vibration) high
- Sensor opening internally with temperature changes medium
- Corrosion or moisture in the connector medium
Symptoms
- Check engine light on
- Jumping coolant readings
- Usually no change in driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P01E7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.