P01E1
Cylinder 12 Injection Timing Performance - Over Retarded
Diesel engines must detect when fuel can no longer be injected at the correct crank angle – CARB requires this for every injector individually, hence one code per cylinder. The start of injection is not measured directly: during overrun with fuel cut-off the control module fires a tiny test injection into one cylinder (GM: about 1.5 mm³) and evaluates the resulting speed change at the crankshaft sensor. From this it learns how much extra energizing time the injector needs (Bosch calls this zero fuel calibration). This code means injector 12 needs clearly more energizing time than intended, i.e. it opens too late – GM sets it above 80 µs of extra time, after two trips. No manufacturer document using the codes for cylinders 9–12 was found; the description follows CARB's requirement and the documented measuring principle (Bosch patent, GM tables for cylinders 1–8). Such codes can only appear on engines with at least that many cylinders.
Possible causes
- Injector worn, coked or sticking (opens late, delivers too little) high
- False setting from software or vehicle vibration (e.g. off-road tyres) medium
- Wrong injector correction code stored after an injector replacement medium
- Boost leak or loose injector clamp low
- Contaminated fuel low
Symptoms
- Check engine light on (after two drive cycles)
- Louder combustion noise or knocking
- Rough idle
- Possibly smoke
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P01E1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.