OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P01DA

Cylinder 8 Injection Timing Performance - Over Advanced

Diesel engines must detect when fuel can no longer be injected at the correct crank angle – CARB requires this for every injector individually, hence one code per cylinder. The start of injection is not measured directly: during overrun with fuel cut-off the control module fires a tiny test injection into one cylinder (GM: about 1.5 mm³) and evaluates the resulting speed change at the crankshaft sensor. From this it learns how much extra energizing time the injector needs (Bosch calls this zero fuel calibration). This code means injector 8 needs clearly less energizing time than intended, i.e. it opens too early or delivers too much – GM sets it below −90 µs, after two trips. The documented user for this cylinder is GM's 6.6 litre Duramax V8 (LML, L5P); Ford reports the same function under P2B11ff. GM fixed false settings on 2020–2021 L5P trucks with new software and warns that vibration, for example from off-road tyres, disturbs the evaluation, so injectors should not be replaced before that is ruled out.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / DA

Possible causes

  • Injector worn or leaking (delivers too much in small quantities) high
  • False setting from software or vehicle vibration (e.g. off-road tyres) medium
  • Wrong injector correction code stored after an injector replacement medium
  • Boost leak or loose injector clamp low
  • Contaminated fuel low

Symptoms

  • Check engine light on (after two drive cycles)
  • Louder combustion noise or knocking
  • Rough idle
  • Possibly smoke

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P01DA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication