P01CC
Cylinder 1 Injection Timing Performance - Over Advanced
Diesel engines must detect when fuel can no longer be injected at the correct crank angle – CARB requires this for every injector individually, hence one code per cylinder. The start of injection is not measured directly: during overrun with fuel cut-off the control module fires a tiny test injection into one cylinder (GM: about 1.5 mm³) and evaluates the resulting speed change at the crankshaft sensor. From this it learns how much extra energizing time the injector needs (Bosch calls this zero fuel calibration). This code means injector 1 needs clearly less energizing time than intended, i.e. it opens too early or delivers too much – GM sets it below −90 µs, after two trips. Documented users are GM's 6.6 litre Duramax (LML, L5P) and FCA's 3.0 litre EcoDiesel; Ford reports the same function under P2B11ff. Bulletins often point away from the injector: GM fixed false settings on 2020–2021 L5P trucks with new software and warns that vibration, for example from off-road tyres, disturbs the evaluation; FCA lists wrong injector correction codes, boost leaks and loose injector clamps.
Possible causes
- Injector worn or leaking (delivers too much in small quantities) high
- False setting from software or vehicle vibration (e.g. off-road tyres) medium
- Wrong injector correction code stored after an injector replacement medium
- Boost leak or loose injector clamp low
- Contaminated fuel low
Symptoms
- Check engine light on (after two drive cycles)
- Louder combustion noise or knocking
- Rough idle
- Possibly smoke
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P01CC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.