OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P01CA

Fuel Rail Pressure Too Low - Engine Cranking Bank 2

Some V engines have a separate high-pressure fuel circuit per bank, each with its own pump or rail – for example Audi's 4.0 TFSI V8 with a second high-pressure pump for bank 2. These codes are the bank 2 counterparts of the system pressure codes for bank 1. P01CA is the bank 2 counterpart of P00C6: during cranking the rail pressure on bank 2 does not rise quickly enough to the minimum needed to release injection. For bank 1 GM checks once per start that pressure exceeds about 3 MPa and does not fall below 2 MPa, with two trips. No manufacturer using exactly this code was found; GM's two-rail LT6 reports the same situation with the bank-neutral P00C6.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / CA

Possible causes

  • High-pressure pump of bank 2 or its drive weak high
  • Low supply pressure at start (lift pump, check valve) medium
  • Leak or leaking injector on bank 2 medium
  • Bank 2 rail pressure sensor or connector low

Symptoms

  • Check engine light on
  • Long cranking or no start
  • Rough running right after start

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P01CA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication