OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P01C6

Fuel Pressure Sensor A Circuit High

Fuel pressure sensor A is a fuel pressure sensor without 'rail' in its name and without a bank – unlike the rail pressure sensors P0190–P0194 and P01BE–P01C2; which sensor it is depends on the manufacturer. The only documented case is FCA, where sensor A is the low-pressure sensor in the supply line, read together with the fuel pump control module. GM calls its low-pressure sensor 'sensor B' (P018A–P018E). P01C6 means the signal voltage is above its upper limit – typically an open sensor ground or a short to voltage. FCA documents it together with P025C (fuel pump module control low) and P016F (pressure control at its limit, pressure too low), sometimes with no start or stalling; the checks cover the low-pressure sensor connector, a ground point, the pump control module and the tank pump module for corrosion, water and pin damage.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / C6

Possible causes

  • Corrosion, water or pin damage at sensor, pump module or ground point high
  • Sensor ground open medium
  • Signal wire shorted to voltage medium
  • Sensor faulty medium

Symptoms

  • Check engine light on
  • Hard starting or stalling possible
  • Hesitation or lack of power under load

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P01C6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication