P01C2
Fuel Rail Pressure Sensor Circuit Intermittent/Erratic Bank 2
The bank 2 rail pressure sensor measures the pressure in a second, separate high-pressure rail on V engines that have one rail with its own sensor per bank. Many V engines connect both rails and use only one sensor (P0190–P0194); the only documented user of the bank 2 codes is GM's 5.5 litre LT6 (Corvette Z06 2023–2024) with a digital sensor per rail. P01C2 covers jumps or dropouts in the signal of the bank 2 sensor – the counterpart of P0194, for which GM uses a jump of more than 15 MPa between samples 6.25 ms apart. Loose contacts and corroded connectors are the typical causes. No manufacturer document using exactly this code was found; the logic follows the bank 1 sensor and CARB's circuit monitoring requirement.
Possible causes
- Corrosion or wear at sensor and harness contacts high
- Harness chafed or loose contact medium
- Rail pressure sensor faulty internally medium
Symptoms
- Check engine light on (depending on manufacturer)
- Brief stumbling
- Often no symptoms
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P01C2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.