P01C0
Fuel Rail Pressure Sensor Circuit Low Bank 2
The bank 2 rail pressure sensor measures the pressure in a second, separate high-pressure rail on V engines that have one rail with its own sensor per bank. Many V engines connect both rails and use only one sensor (P0190–P0194); the only documented user of the bank 2 codes is GM's 5.5 litre LT6 (Corvette Z06 2023–2024) with a digital sensor per rail. P01C0 means the signal of the bank 2 sensor is too low – the counterpart of P0192: a signal wire shorted to ground or an open 5 V reference. On bank 1 GM's diesels use below 4.3 % of supply. No manufacturer document using exactly this code was found; the logic follows the bank 1 sensor and CARB's circuit monitoring requirement. On a fault the module uses a substitute value and usually limits power.
Possible causes
- Signal wire shorted to ground, harness chafed high
- 5 V reference open or shorted medium
- Connector corroded or loose medium
- Rail pressure sensor faulty internally medium
Symptoms
- Check engine light on
- Limp mode or 'Reduced Engine Power'
- Hard starting, stalling
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P01C0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.