OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P01BC

Engine Oil Temperature Sensor B Circuit High

The engine oil temperature sensor B is an NTC thermistor fed with 5 V through a resistor: the hotter the oil, the lower the signal voltage. The engine module uses the oil temperature for variable cam timing (Ford disables it with cold oil or a sensor fault), engine protection and the oil life monitor; many engines have no such sensor and use a calculated oil temperature instead. Sensor B is a second oil temperature sensor whose position is defined by the manufacturer. P01BC means the signal of sensor B sits near the reference voltage – it would report very cold oil; typically an open circuit, unplugged connector or short to voltage. Thresholds are presumably similar to sensor A (GM above 450 kΩ after 20 s of running), but are not documented for B. No manufacturer document using the B-sensor codes was found, so it is unclear who fits a sensor B; the description follows sensor A and CARB's circuit monitoring requirement.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / BC

Possible causes

  • Connector or wire of sensor B open high
  • Sensor B open medium
  • Short to voltage low
  • Control module low

Symptoms

  • Check engine light on (depending on manufacturer)
  • Oil temperature shows minimum
  • Usually no driving symptoms

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P01BC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication