P01B8
Alternative Fuel Rail Temperature Sensor Circuit Intermittent/Erratic
These codes only apply to vehicles with a gaseous alternative fuel – compressed natural gas (CNG) or LPG – as bi-fuel models alongside petrol or as dedicated gas engines; on bi-fuel vehicles a fault usually blocks gas operation and the vehicle runs on petrol. The gas rail temperature sensor, often combined with the rail pressure sensor, measures the gas temperature at the injectors: gas cools strongly when it expands in the regulator, and the injected mass depends on density, i.e. on rail pressure and temperature, so the module corrects injection time with it. A Ford patent describes plausibility checks against engine bay temperature at idle and an expected cold rail at full load with a full tank. Roush propane systems report rail temperature faults as P0181–P0183; no manufacturer document using exactly this code was found. P01B8 covers brief dropouts or jumps in the signal, typically a loose contact or heat-damaged wiring near the engine.
Possible causes
- Loose contact or corrosion at the connector high
- Harness chafed along the gas line or underbody medium
- Sensor unstable internally medium
Symptoms
- Check engine light on
- Gas operation blocked or switch to petrol
- Mixture errors or stumbling in gas mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P01B8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.