OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P01B5

Alternative Fuel Rail Temperature Sensor Performance

These codes only apply to vehicles with a gaseous alternative fuel – compressed natural gas (CNG) or LPG – as bi-fuel models alongside petrol or as dedicated gas engines; on bi-fuel vehicles a fault usually blocks gas operation and the vehicle runs on petrol. The gas rail temperature sensor, often combined with the rail pressure sensor, measures the gas temperature at the injectors: gas cools strongly when it expands in the regulator, and the injected mass depends on density, i.e. on rail pressure and temperature, so the module corrects injection time with it. A Ford patent describes plausibility checks against engine bay temperature at idle and an expected cold rail at full load with a full tank. Roush propane systems report rail temperature faults as P0181–P0183; no manufacturer document using exactly this code was found. P01B5 is the plausibility fault: the reading is valid but does not fit the expected gas temperature.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / B5

Possible causes

  • Sensor drifting or stuck high
  • Regulator coolant heating faulty (gas genuinely too cold) medium
  • Contact resistance in the connector medium

Symptoms

  • Check engine light on
  • Gas operation blocked or switch to petrol
  • Mixture errors or stumbling in gas mode

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P01B5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication