OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P01B2

Alternative Fuel Tank A Level Sensor Circuit High

These codes only apply to vehicles with a gaseous alternative fuel – compressed natural gas (CNG) or LPG – as bi-fuel models alongside petrol or as dedicated gas engines; on bi-fuel vehicles a fault usually blocks gas operation and the vehicle runs on petrol. Tank level sensor A only exists where there is a real sender – typically LPG tanks with a float whose position is transmitted magnetically through the tank wall (Roush propane systems: 0.1–4.9 V). With CNG the 'level' is a calculated value. The documented systems report level faults under the petrol fuel level codes (Roush propane P0460–P0463, GM CNG van P0463), so no manufacturer document using exactly this code was found. P01B2 means the signal voltage is above its upper limit – typically an open circuit or a short to voltage.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / B2

Possible causes

  • Open circuit, connector unplugged high
  • Sensor open internally medium
  • Short to voltage low
  • Gas or engine module low

Symptoms

  • Check engine light on
  • Gas level display wrong, jumping or empty
  • Range or refuelling information unreliable

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P01B2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication