OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P01AE

Alternative Fuel Tank Temperature Sensor Circuit Intermittent/Erratic

These codes only apply to vehicles with a gaseous alternative fuel – compressed natural gas (CNG) or LPG – as bi-fuel models alongside petrol or as dedicated gas engines; on bi-fuel vehicles a fault usually blocks gas operation and the vehicle runs on petrol. The tank temperature sensor is an NTC thermistor: with CNG there is no float, so the gas level is calculated from tank pressure and tank temperature (GM: full at about 3600 psi at 21 °C, empty at about 400–500 psi). On GM's 2015 Impala Bi-Fuel the sensor is built into the tank and cannot be replaced separately. P01AE covers brief dropouts or jumps in the signal, typically a loose contact or a harness chafing along the underbody. The Roush propane conversion for Ford E- and F-series trucks (2016–2018) uses this code for its combined tank pressure/temperature sensor (NTC, 8–12 kΩ at 20–30 °C), with the signal travelling via its own module and CAN to the engine module; according to its table the code does not light the MIL.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / AE

Possible causes

  • Loose contact or corrosion at the connector high
  • Harness chafed along the gas line or underbody medium
  • Sensor unstable internally medium

Symptoms

  • Stored fault code (warning light depending on system)
  • Gas level display wrong
  • Gas operation blocked, switch to petrol

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P01AE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication