P01AD
Alternative Fuel Tank Temperature Sensor Circuit High
These codes only apply to vehicles with a gaseous alternative fuel – compressed natural gas (CNG) or LPG – as bi-fuel models alongside petrol or as dedicated gas engines; on bi-fuel vehicles a fault usually blocks gas operation and the vehicle runs on petrol. The tank temperature sensor is an NTC thermistor: with CNG there is no float, so the gas level is calculated from tank pressure and tank temperature (GM: full at about 3600 psi at 21 °C, empty at about 400–500 psi). On GM's 2015 Impala Bi-Fuel the sensor is built into the tank and cannot be replaced separately. P01AD means the signal voltage is too high – with an NTC an apparently very cold tank, typically an open circuit (Roush names this as the cause) or a short to voltage. The Roush propane conversion for Ford E- and F-series trucks (2016–2018) uses this code for its combined tank pressure/temperature sensor (NTC, 8–12 kΩ at 20–30 °C), with the signal travelling via its own module and CAN to the engine module; according to its table the code does not light the MIL.
Possible causes
- Open circuit, connector unplugged high
- Sensor open internally medium
- Short to voltage low
- Gas or engine module low
Symptoms
- Stored fault code (warning light depending on system)
- Gas level display wrong
- Gas operation blocked, switch to petrol
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P01AD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.