P01A7
Alternative Fuel Rail Pressure Sensor Circuit Intermittent/Erratic
These codes only apply to vehicles that run on a gaseous alternative fuel – compressed natural gas (CNG) or LPG – either as bi-fuel models alongside petrol (for example GM's 2015–2016 Impala Bi-Fuel or 2013–2016 Silverado/Sierra 2500HD) or as dedicated gas engines. CNG is stored at up to about 250 bar (3600 psi); a regulator reduces it to a few bar for the gas rail and injectors. The gas rail pressure sensor measures the regulated low pressure at the rail – on GM's Impala controlled by the engine module to 68–130 psi (about 4.7–9 bar) – so that injection time can be matched to the actual gas pressure and density. P01A7 covers brief dropouts or jumps in the signal – typically a loose contact, corroded connector or a wire broken by engine movement. Typical reaction: gas operation is blocked and a bi-fuel vehicle switches to petrol. No manufacturer document naming exactly this code was found; GM's bulletins only state that faults are reported like on petrol models. The description rests on CARB, which treats such vehicles like petrol engines for model years 2004–2018, and on the documented system design.
Possible causes
- Loose contact or corrosion at the connector, wire broken by engine movement high
- Sensor unstable internally medium
- Ground or reference problem low
Symptoms
- Check engine light on
- Switch to petrol or gas operation not selectable
- Hesitation, loss of power or mixture faults in gas mode
- Dedicated gas engines: limp mode or starting problems
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P01A7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.